CFD Beginner Courses
Here's every CFD online course in the Beginner level.
Lifting Dam CFD Simulation, Ansys Fluent Training
Beginner, Intermediate
Price: $24
In this project, two different cases of lifting dams have been simulated and the results have been investigated.
Price: $12
In this project, Fountain Waterfall has been simulated and the results have been investigated.
Serrated Vs. Plain Airfoil: Darrieus VAWT
Beginner, Intermediate, Advanced
Price: $72
This project uses ANSYS Fluent to numerically simulate and compare a serrated-airfoil and a plain-airfoil turbine. The 3D model is built in Design Modeler. The model is meshed in ANSYS Meshing, with an element count of 1,186,185. The simulation is run as unsteady (transient). The rotating motion of the turbine blades is defined using the Mesh Motion option.
Price: $80
The problem numerically simulates heat transfer through the underfloor heating system by spiral pipe using ANSYS Fluent software. We design the 3-D model by the Design Modeler software. We Mesh the model by ANSYS Meshing software, and the element number equals 2936179. We use the Ideal Gas option for the air density to consider free convection.
Side Supply Air Conditioning, Paper CFD Validation
Beginner, Intermediate
Price: $160
The problem numerically simulates Air Conditioning (Side Supply) using ANSYS Fluent software. This project is validated with a reference article. We design the 3-D model by the Design Modeler software. We mesh the model with ANSYS Meshing software, and the element number equals 1027974. The Energy Equation is activated, and heat flux is applied to the walls as heat sources.
Conjugated Heat Transfer, Elliptical Finned Tube Heat Exchanger Vs. Circular Fin
Beginner, Intermediate
Price: $160
In this project, by investigating conjugated heat transfer, the effect of cross-sectional change (with the constant area) on the rate of improvement of heat flux passing through the circular and elliptical finned tube heat exchanger was compared.
Price: $28
The problem simulates a two-phase flow (water and air) inside an open channel with a 180-degree arc using ANSYS Fluent software.
Price: $12
The problem numerically simulates the Towel Warmer using ANSYS Fluent software. We design the 3-D model by the Design Modeler software. We Mesh the model by ANSYS Meshing software. The mesh type is Structured, and the element number equals 475344. The Energy Equation is activated to consider convective heat transfer from pipes.
Price: $16
The problem numerically simulates the heat transfer of water flow inside a microchannel heat sink using ANSYS Fluent software. We design the 3-D model with the Design Modeler software. We mesh the model with ANSYS Meshing software. The mesh type is Structured, and the element number equals 1500000. The Energy Equation is activated to consider heat transfer.