Electrical & Power Online Courses

Price: $240

This project investigates the thermal management of an electronic engine using CFD simulation through ANSYS Fluent software suite The primary objective was to compare the cooling effectiveness of the engine under two conditions: without water spray cooling and with water spray cooling The simulation workflow began with geometry creation in SpaceClaim, followed by mesh generation in ANSYS Meshing. The simulation framework utilised species transport modelling and implemented a two-way coupled discrete phase model (DPM) specifically for water spray simulation

Price: $200

In this comprehensive study, three distinct cases were investigated to analyze the effectiveness of spray cooling approaches utilizing ANSYS Fluent software. The simulation setup began with the creation of detailed geometry using SpaceClaim, followed by the generation of a high-quality quadrilateral mesh in ANSYS Meshing. Three simulation cases were compared: baseline airflow only (Case 1), water injection with inert particles (Case 2), and water injection with droplet interactions and phase change A two-way coupling approach was employed in the DPM configurations to capture the complete interaction between the discrete phase and the continuous flow field.

Price: $54

In this product, we conducted a comprehensive study comparing two distinct cases1) A conventional PV panel without pCM 2) An enhanced system incorporating PCM cooling technology comprehensive three-dimensional model was developed using ANSYS SpaceClaim,The computational domain was discretized using ANSYS Meshing software, employing a structured grid approach with approximately 1,000,000 elements The Solidification and Melting model was activated to accurately capture the phase change dynamics of the PCM The Discrete Ordinates (DO) radiation model was implemented to account for radiative heat transfer Solar Ray Tracing was enabled for precise solar load calculations

Price: $200

The computational fluid dynamics (CFD) analysis of a Francis turbine was conducted using ANSYS Fluent software to investigate its performance characteristics and flow behavior. This study aims to provide detailed insights into the pressure distribution, velocity patterns, and potential cavitation phenomena within the turbine system. The simulation incorporates advanced numerical models and careful consideration of boundary conditions to ensure accurate results.

Price: Free

Introduction to the Battery Model in ANSYS Fluent software Introduction to the Battery System Operation Introduction to the Solution Methods (CHT, FMU-CHT, Circuit Network, MSMD) Introduction to the Electrochemistry Models (NTGK, ECM, Newman P2D) Introduction to the Battery Model Settings

Price: $9

Introduction to the Battery Model in ANSYS Fluent software Introduction to the Solution Methods (CHT, FMU-CHT, Circuit Network, MSMD) Introduction to the Electrochemistry Models (NTGK, ECM, Newman P2D) Introduction to the Battery Module and Battery Pack (Parallel and Series) Introduction to the Real Connection and Virtual Connection Introduction to the Thermal Abuse, Battery Life, and Pack Builder options

Price: $20

The project utilized the ANSYS software suite to simulate and analyze the fluid behavior and cavitation characteristics under specific operating conditions. The initial phase of the project involved geometry creation using ANSYS Design Modeler, followed by mesh generation in ANSYS Meshing. The multiphase modeling approach utilized the Volume of Fluid (VOF) method, coupled with cavitation mechanisms to accurately represent the two-phase flow dynamics

Price: $60

this report presents a FSI analysis of a HAWT using CFD. The geometry was created using ANSYS Design Modeler, and meshing was performed with ANSYS Meshing, resulting in a high-fidelity model with 3,465,821 cells. The simulation leverages (MRF) approach for rotating domains and dynamic mesh methods to capture the complex fluid-structure interactions. A two-way FSI approach was employed to capture the mutual interaction between the fluid flow and the structural deformation of the turbine blades.

Price: $40

we are simulating the solar panel that is floated on the water surface,The simulation is 3D and the solar panels and performed by ANSYS Fluent. The geometry is designed using Spaceclaim software. Then, it is meshed in ANSYS Meshing. In total 479895 cells are generated. phases are modeled by Volume of Fluid multiphase model. The dynamic mesh can reproduce elements by remeshing and smoothing types. Also, the radiation is activated.